[Elecraft] error SPE

[Igor Sokolov]

Peter,
This subject is more appropriate on the reflector  expertamp at yahoogroups.com
I have similar setup (K3 and SPE Expert 1k-FA) but there is not enough data 
in you message to figure out what is happening.
What kind of cable you are using?
Does the amp follow radio from band to band in RX mode?
Does error show up when you press PTT or is it happening when drive power is 
applied?
May I suggest that you subscribe to the above mentioned reflector and 
describe all the details. I am sure you will get help there.

73, Igor UA9CDC

----- Original Message ----- 
From: "peter" <p.boorsma2 at chello.nl>
To: "Elecraft" <elecraft at mailman.qth.net>
Sent: Sunday, February 19, 2012 11:35 PM
Subject: [Elecraft] error SPE


> Hello list,
>
> Iam working with the K3 and SPE expert.
> Everything whas working fine until i change wirring setup.
> I went using the data/band/alc cable and now everytime i give ptt i get a
> error.
> In the P.A. management PA Protection internal hardware protections
> intervention.
> I have no idea what i did wrong i did not over powered the drive etc.etc.
> I work the whole PACC contest on half power and not a problem at all.
> So some help is needed.
>
> 73s
>
> peter,PD1RP
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html