[Elecraft] [K2] Hi Current...still

Don Wilhelm w3fpr at embarqmail.com
Sun Feb 19 08:29:38 EST 2012


Brian,

Put an external wattmeter between the K2 and the dummy load - set the 
power for 5 watts, do a TUNE and see how much power is really being 
produced.

If it is much higher than the 5 watts requested, you have a power 
control problem - which will usually result in a Hi Cur message because 
all transmit stages are producing as much as they possibly can.

If this is actually your situation, do not transmit for more than a 
brief moment or you can damage those new PA transistors.

73,
Don W3FPR

On 2/18/2012 10:09 PM, b.denley at comcast.net wrote:
>
> After getting the HiCur message, I replaced the two PA transistors, the associated hardware, Q11 and Q13, and R50.  Unfortunately I stll get the same message:  HiCur when I press TUNE with power any higher than about 1.5 watts  inot a 50 ohm dummy load.  Any have any ideas about what else might cause this problem?
>
>
>
> Brian KB1VBF


More information about the Elecraft mailing list