[Elecraft] K3 TX delay

[Sam Morgan]

confused by all this K3 TX DLY chatter
please answer the following question(s)

my cw operation is with Simi QSK @ 13-25wpm
sometimes with a straight key
but most times using the internal K3 keyer

so are you saying.....
I shouldn't run the K3 with my older AL-811 (3 tube)
or I will be transmitting these chopped off cw characters

or would this only happen if I were to use FAST QSK
or is it ok in either Slow or Fast
as long as I stay below about 30wpm

also, if I can use the K3 and AL-811,
in either or both QSK modes,
what TX DLY setting should be used

--
GB & 73
K5OAI
Sam Morgan

On 2/15/2012 11:03 AM, Jim Brown wrote:
> El cheapo amps
> with open frame relays (like some MFJ/Ameritrons I've seen) are never
> going to follow CW, no matter what is done at the rig.