[Elecraft] My new K3 has arrived on Saturday

[Richard Ferch]

Oli,

Your first problem is probably caused by HRD.

On your second problem, it sounds as if your Line In level is still set 
to zero. With MAIN:MIC SEL set to LINE IN (this is remembered separately 
for SSB and Data modes), the Mic gain control adjusts the Line In level. 
Adjust this control until you see 4-5 bars on the K3's ALC meter.

73,
Rich VE3KI

DL1OLI wrote:

> Now I have =A0two problems:
> 1. If I use the DX-cluster in HRD Logbook an click on an dx-entry which
> is not on the same band where the K3 is, then the K3 changes to the new
> frequency, an directly after it goes back to the old frequency. For
> example. The K3 is on 14300 kHz, in the HRD-Logbook dx-cluster is an
> entry for 21400 kHz. Then the K3 changes shortly to 21400 and
> immediately goes back to 14300. ?
>
> 2. The rear line-in does not work. I connected my sound-card to the
> line-in with an 3.5 mm mono connector on the radio-end. I used the MAIN
> menu to change the source to line in. But tthen it does not modulate on
> TX. If I connect the same cable from the sound-card in the rear
> microphone instead of line-in, then the K3 modulates. I tried USB and
> DATA A modes. The Sound-card and cable is OK because it works in the
> rear-mic. =A0?