[Elecraft] KPA500 Z Bracket & Top Cover

[K9TM]

I noticed this but didn't let it bother me.  I just looked again and if I push down on the top cover, it goes down flush or a little below flush.  I wouldn't say that the z-bracket is the problem (if there is a problem).  I didn't take the top cover off to see how possible this is but my initial suggestion (if anything were to be done) would be to add another screw closer to the front panel or to move the existing hole forward closer to the front cover.  At least on my unit, SN49, this would make it flush.  This is not an issue on the rear because of the tab and screw that holds the tab down.

I guess someone may suggest some really really thin but really really sticky tape to hold this down without any screws but I wouldn't do that.  If the case stuck up high enough that I could see inside the amp (under the cover), it would bother me but as is as long as it keeps putting out the appropriate amount of watts... I'm more than satisfied as is!

73, Tim K9TM, KP2TM

On Feb 10, 2012, at 10:55 PM, iain macdonnell - N6ML wrote:

On Fri, Feb 10, 2012 at 6:54 PM, Chuck - AE4CW <AE4CW at att.net> wrote:
> Just finished a KPA500 build and all went smoothly.  The only issue I see is
> that the Z-Bracket appears to be about 1mm taller at the front than at the
> rear.  The result is that the top cover protrudes above the front panel in
> the center by a small amount, perhaps 1mm.  At the rear the top cover is
> flush with the rear panel in the center...no protrusion at all.  This is a
> cosmetic issue but does detract a bit for the "fit and finish" of the rest
> of the KPA500 and the K3.
> 
> Has anyone else seen this issue?  Thought I would ask before calling home.

Yes, I have exactly the same issue, but I don't have a solution. It
hasn't bothered me enough to pursue it with support, but I couldn't
see any way that it could have been caused by incorrect assembly, so
it must be a malformed Z-bracket.....

Let me know if you find a solution!

   ~iain / N6ML
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html