[Elecraft] KPA500 Z Bracket & Top Cover

[Chuck - AE4CW]

Just finished a KPA500 build and all went smoothly.  The only issue I see is
that the Z-Bracket appears to be about 1mm taller at the front than at the
rear.  The result is that the top cover protrudes above the front panel in
the center by a small amount, perhaps 1mm.  At the rear the top cover is
flush with the rear panel in the center...no protrusion at all.  This is a
cosmetic issue but does detract a bit for the "fit and finish" of the rest
of the KPA500 and the K3.

Has anyone else seen this issue?  Thought I would ask before calling home.
---
Chuck, AE4CW

--
View this message in context: http://elecraft.365791.n2.nabble.com/KPA500-Z-Bracket-Top-Cover-tp7275169p7275169.html
Sent from the Elecraft mailing list archive at Nabble.com.