[Elecraft] K3: CW in SSB mode broken?

[Frank R. Oppedijk]

Hi Gary, group, Elecraft support,

I think I have found a strong correlation between CW in SSB not 
working and the QRQ setting. Here follows:

To make CW in SSB work: set CONFIG:QRQ to OFF, power-cycle the K3.

To break CW in SSB: set CONFIG:QRQ to ON, power-cycle the K3.

73,

Frank PA4N



At 21:36 31/01/2012, Gary Hinson wrote:
>Hi Frank.
>
>I have the same problem: CW in SSB no longer works on K3#2887 running
>firmware 4.39.  I raised this on the reflector some months back and went
>around the loop changing config settings, PTT, QRQ etc.  I did manage to fix
>it temporarily by restoring the K3 firmware configs, but annoyingly it has
>packed up again since then.
>
>I *think* CW-in-SSB it might still work on some bands, not others.  At
>least, that's what I found last time I checked - I haven't checked lately.
>
>I suspect there might be a cryptic bug in the firmware (the best kind!).
>
>73
>Gary  ZL2iFB