[Elecraft] Where does my K3 transmit?

[Don Wilhelm]

Fred,

PSK31 (or any other DATA A modes - the signal frequency is the carrier 
frequency (indicated by the VFO readout) plus (or minus) the audio 
frequency on the waterfall display.

RTTY will be the same if you are using DATA A mode - if you are using 
AFSK  mode, the displayed frequency will be the mark frequency - but 
that is not relevant to the 60 meter allocations, only Pactor III and 
PSK31 will be permitted after March 5, 2012.

73,
Don W3FPR.


On 2/4/2012 5:20 PM, Fred Jensen wrote:
> I had forgotten that the K3 will transmit PSK31 and RTTY without an
> external computer.  So,
>
> MODE        TX FREQ
> -------------------
> CW          What the dial reads
> USB         Supp Carrier at the dial, energy up
> LSB         Supp Carrier at the dial, energy down
> RTTY        ???
> PSK31       ???
>
> I know on CW, if a station is transmitting on 14050.000 KHz and I set
> his tone in my cans to 570 Hz [my PITCH frequency], I will be
> transmitting exactly on his frequency and if you were listening, we'd
> sound the same to you, and my VFO will read 14.050.000  I don't know how
> the K3 brings that off, and really don't care, I just know it does.
>
> I've never used the paddle -->  RTTY or PSK31.  Any help on how that
> works?  I didn't find it in KT7X's book, but I'm poking around in the
> MNQP and didn't spend a lot of time looking, the Minnesota Mobiles
> change counties fast :-)
>
> 73,
>
> Fred K6DGW
> - Northern California Contest Club
> - CU in the 2012 Cal QSO Party 6-7 Oct 2012
> - www.cqp.org
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>