[Elecraft] KX3: No Transmit in SSB following ATU TUNE

[Chris Mallam]

Don Butler n5lz said,

"After activating ATU TUNE my KX3 will not transmit in USB or LSB.
BUT....Cycling the mode button to CW and then back to SSB always corrects
the problem.  There has never been a problem on CW . just USB or LSB."

Serial #188
I never had this particular problem until I was experimenting with cw text
decode the last time I used the radio (out in the field). Until that point
the radio had always been in SSB mode. Even when I had the problem, it
didn't occur in split mode.

When it happened, only one bar 'lit up' on the RF power meter, and there
was no apparent modulation.

Elecraft have suggested that if the problem persists, I may have to do an
EEINIT, with all the cautions mentioned in the manual.

VA3CME