[Elecraft] Two Inputs for PTT ?

[Jim Rhodes]

No problem to parallel as many inputs to PTT as you desire. Just make sure
that the ones you aren't currently using are open. I have foot switch and
Remoterig on a simple Y connector from radio shaft.

On Wed, Aug 15, 2012 at 3:26 PM, paul ecker <eckerpw at yahoo.com> wrote:

> Hope I am not expending my quota of dumb questions but hey I  am new. Got
> my Tx foot switch plugged into the back panel PTT jack  and it works fine.
> My next project is to get my SignaLink USB up and running with the K3. I
> know I can do lots without it but I would like to not use the PC sound
> card. So here's my problem- I got the SLCABK3 cable from Tigertronics which
> has 3 leads on radio end: Line In, Line Out and PTT. But the my PTT jack
>  is used already. What it i were to make a Y cable allowing two PTT inputs
> to the K3. Signalink only used for digital modes, so it's an either or
> situation, both would not be used at the same time.
> - Is this doable, not going to harm the K3? anyone else encounter this
> problem?
> 73 & tnx
> Paul kc2nyu
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>



-- 
Jim K0XU
jim at rhodesend.net