[Elecraft] feedback in K3

[N5GE]

Having the 1 setting so low will also make your signal mushy and hard to
understand.  Remember, commercial broadcast quality will widen your signal and
make it difficult to understand in conditions where the atmospheric noise level
is above normal.

Amateur Radio Operator N5GE
ARRL Lifetime Member
QCWA Lifetime Member

On Tue, 14 Aug 2012 22:54:46 -0400 (EDT), Scott Dunlavey <sdunlavey at optimum.net>
wrote:

>Hello agn... I cant figure what I have set wrong...  I have set up the 
>eq on the K3 in transmit the following way...  1=+12  2=+10  3=-1   4= 
>-1   5= 0  6= -1  7=0  8 = +2  Rx is the same....  (this is how I had it 
>set for the w2ihy EQ...)    as I am trying to set the mic gain and 
>monitor levels  I get a lot of feedback in my headphone.very loud..  My 
>monitor level is very low... compression has NOT been adjusted because 
>of the feedback so that is at zero....  I have a heil pro20 running to 
>the front of the K3... any ideas
>
>
>scott
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html