[Elecraft] WSPR

[Dave Van Wallaghen]

Hi Scott,

I'm going to assume you are talking about a K3 here (red light comes 
on). I'm successfully running WSPR here on K3 #338. Here is my setup:

- Using DATA A mode (make sure you're not in REV DATA).
- While in TEST mode, I adjusted my sound card output to show a solid 4 
bars on the ALC meter with the 5th bar flickering.
- Adjust the CONFIG:LINE OUT so that you see around 0db RX noise 
displayed at the bottom of the WSPR application while it is receiving.

I'm currently testing a new antenna on 40m running 1W. I will be around 
this morning if you would like me to monitor you or offer any other 
suggestions.

Hope this helps.

73,
Dave W8FGU




On 8/13/2012 8:13 AM, Scott Dunlavey wrote:
> Hello ...
> I seam to have something set wrong... I can rx and tx while doing
> PSK/RTTY... BUT doing WSPR I don't seam to be heard and I cant hear...
> It acts like it is transmitting.. (red light comes on) and I hear the
> packet bursts... what could I be doing wrong
>
> scott
> w2ntv
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>