[Elecraft] K3/100 PA Removal

[Ron D'Eau Claire]

Removing the KPA3 module is a straightforward process and should not result
in *any* damage, Hi! The process is documented in a mod sheet describing a
very desirable change to the connectors in early K3s, but I can't find it on
the Elecraft web site. So look for a direct e-mail message; I'll attach it
for you. 

73, Ron AC7AC

-----Original Message-----

I have a K3 which I recently inherited.

Unknown to me at the time, it has no TX/RX on 160m. The Guys at Support led
to look for a possible fault in the Low Pass Filter area.
I believe that this is beneath the 100W PA unit on the main board.

What is the easiest/safest way to remove the PA unit without causing
unnecessary damage?
Also, is there a layout drawing of the main board?

Thanks Roger G0IUW
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html