[Elecraft] K3 and EasyPal

[David Moes]

So I managed to figure it out

the problem is that EasyPal does not document this very well first off 
you need to enter the Cat Commands in HEX rather then plain text.     
The initial and exit strings are sent on start and end of 
transmission.        The downfall here is when I return to recieve    I 
the MD command defines upper or lower sidband . so I need two different  
sets of commands for 40m and down and 20 and up      I wish there was a 
way to set the K3 back to SSB to what ever sideband it was in before.



On 8/10/2012 8:57 PM, david Moes wrote:
> I have a question for any EasyPal users out there
>
> I am using my K3 to send digital images with EasyPal  with great success
> but Id like to simplify my world
>
> since many EasyPal  users talk about the images being sent between
> pictures I
> find that I have to manually change between DIGI-A and SSB manually before
> and after sending. sure I could send with the rig in SSB but this would
> not be
> good as it would include any EQ and signal processing I have set up for
> the mic.
> Id like to change modes automatically when I transmit images
>
> to do this could I use EasyPal CAT PTT    Is there anyone that has done
> this
> successfully using.  The CAT setup menu in EasyPal has "Initial string"
> and "exit string".
> are these sent at the start of each transmission? or at the initial
> launch of
> easypal?  I was thinking of using this to send a mode change command at
> the start and end of each picture.   Any suggestions would be appreciated.
>
> Dave
> VE3DVY
>
>