[Elecraft] K3/P3 Question

[Fred Jensen]

OK Alan, that answers my question.  It probably would be nice ... at 
least in this situation but others may come up with counter examples ... 
that it went back to where I had it set, but this is a pretty small 
thing.  Whenever you're bored and looking for something to do, like that 
ever happens :-)

73,

Fred K6DGW
- Northern California Contest Club
- CU in the 2012 Cal QSO Party 6-7 Oct 2012
- www.cqp.org
On 8/11/2012 6:33 PM, n1al at sonic.net wrote:
> I believe 6474 kHz probably falls within the definition of the 40 meter
> band on the K3.  (I'm not home now so I can't check.)  So when you jump
> back to 7050 the P3 does not use the per-band start/stop frequencies
> stored in EEPROM (since you haven't changed bands) but instead uses the
> algorithm for changing frequencies within a band.  The algorithm prefers
> "even" start frequencies, meaning frequencies divisible by 100 kHz, 50
> kHz, etc.  I probably should tweak the algorithm so that if the band edge
> ends up too close to the K3 VFO frequency it moves down a bit to center
> the VFO better.