[Elecraft] K3 and FM mode.

[Don Wilhelm]

Stan,

It is a matter of 6 or 7 screws to remove the top cover and examine the 
installed filters.
You need to tell K3-EZ which filters you have installed because K3-EZ 
has no mechanism to determine the filter width, that is information that 
you must provide.

 From your filter designations it appears that your FL1 is unpopulated 
in your configuration and that FL2 and FL3 are populated.  Open the top 
cover and check the actual filters installed  This may be a case where 
your filters were not set up properly, or in the worst case, if you 
ordered the 13 MHz FM filter and it is not installed, you have a "beef" 
with Elecraft, and that situation should be promptly resolved.

73,
Don W3FPR

On 8/7/2012 10:51 PM, Stan Grigaliunas wrote:
> I purchased K3/100F in April of this year.  Great little radio.  I began to play with the K3_EZ and when I asked to Scan and populate the “K3 info” I have noticed that under Main Filter Bandwidth the FL1  is vacant and FL2 is 6.0, FL3 is 2.70, FL4 and FL5 are vacant.  I thought I purchased the KFL3B-FM also.  In checking the invoice, I did find the FM filter listed in the invoice.  As of this date, I have not found anyone to talk on 10 meter FM so I am not sure if it is working or not.  My question is, should the FM filter appear on the K3 Info?  If it should, then cracking open the box and physically looking for the FM filter would be my next move.  From reading the manual, I understood that the widest filters should be in FL1 position.  Am I all wet?  73, Stan
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html