[Elecraft] KX3: Missing instructions for screws?

[Buck - k4ia]

Those holes are for the KXPD3 paddles - you can ignore them.  Elecraft 
always gives you some extra hardware - just in case.

Buck
k4ia

On 8/7/2012 11:36 AM, Kevin Luxford wrote:
> When I finished the build of the KX3, there were a couple of small flat
> head black screws left over.  I found a couple of spots where they
> fitted, but for the life of me I could not find reference to them in the
> assembly instructions.  These screws seem to go on either side of a male
> connector visible in the window of a square cut-out on the top cover.
> Further, I could find no reference to this 4 pin connector.  Has it
> something to do with the yet un-released 2 m option and linear amplifier?
>
> I have gone through both the assembly and operator's manuals at least
> three times, however, this is no guarantee that I have not overlooked
> the explanation I am looking for.
>
> 73
> Kevin
> VK3DAP / ZL2DAP
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html