[Elecraft] K3 and the VL-1000 with no ALC connection

[Joe Subich, W4TV]

 > I do not use the ALC connection to the Quadra it will
 > walk back the out put until there is hardly any amplification.

Have you configured the K3 for negative going ALC and adjusted the
Quadra's ALC output as described on pages 12 and 13 of the Quadra
manual?

73,

    ... Joe, W4TV


On 8/6/2012 6:20 PM, Art Nienhouse wrote:
> /*I have two solid state amps I drive using a K3 a KPA500 and a 15 year
> old VL-1000 Quadra I do not use the ALC connection to the Quadra it will
> walk back the out put until there is hardly any amplification.
>
> It works just fine with only the PTT connection,  ACC to band data on
> the VL-1000 for band changing and a ground strap.
>
> Regards
> Art
> ka9zap
> */
>
>
>
>
>
> On 8/6/2012 3:02 PM, OE5CSP-Chris wrote:
>> Dear Jack,
>>
>> I´ve been using my K2 and K3 with the IC2KL for several years and I haven´t
>> used ALC, although this is not recommended by the members of the Yahoo IC2KL
>> group.They say using ALC with this amplifier is a must.
>>    The internal protection of my 2KL works very well here.
>>
>> 73,Chris-OE5CSP
>>
>>
>>
>> --
>> View this message in context: http://elecraft.365791.n2.nabble.com/K2100-and-Icom-2kl-tp7560462p7560482.html
>> Sent from the Elecraft mailing list archive at Nabble.com.
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>