[Elecraft] [K3] P3SVGA Data Terminal in CW Mode

[Adrian]

Not sure about the CR issue, but I use vox. You can set your delay to suit
semi bk in , but qsk works well with it.

Have you tried the vox setting? If you are trying the keyboard slow it down
to your type speed etc, I use 20wpm qsk.
No extra character issues using vox in any case.

I had a bit of fun using the paddle to send rtty in fsk d before and I was
very impressed how well it worked looking
 at my tx text.

It is nice to break the dependency on a pc for this stuff.

Adrian ... vk4tux

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Roy Morris
Sent: Monday, 6 August 2012 11:35 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] [K3] P3SVGA Data Terminal in CW Mode

When I push the ENTER key on my keyboard the CW buffer is transmitted, but
there is an extra character (letter) at the end of the string that I did not
enter into the buffer.  Has anyone else experience this?  If so, what did
you do to eliminate this unwanted character?

In the Transmit Mode and Setup screen I set up the parameters as follows:
Transmit Mode = CR
Transmit Timeout = 0

Thanks,  Roy Morris  W4WFB 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html