[Elecraft] K3 Phones / Diversity Question

[N5GE]

The diversity receive antenna (DRA) must be connected to the AUX antenna on the
back of the K3.  Unless your DRA has the same gain as the transmit antenna you
will need to use a Preamp on the DRA.

I use a DRA that is a 38 inch diameter loop of aluminum tubing that I can rotate
to peak up the signal of the far off station.  That loop has a 35 dB LNA
attached.

Most of us don't have the space to erect a large receive only, so we use smaller
antennae for the DRA.  If you are one who has the property to make a full size
DRA, then you can probably get by without a Preamp unless you locate the DRA as
far away from the TX antenna as possible.  The old ship to shore stations used
to locate the DRA and RX antennas miles from the transmitter, so since most of
us can't do that, here are some links to specialized RX antennas.

http://www.pixelsatradio.com/product/shortwave-magnetic-loop-antenna/

http://www.dxengineering.com/search/department/antennas/brand/dx-engineering/part-type/hf-receive-antennas

Don't let this discourage you.  The antenna I use is the one from PixelSat
Radio, but you can make one just like it yourself if you like to build things.

Amateur Radio Operator N5GE
ARRL Lifetime Member
QCWA Lifetime Member

On Fri, 03 Aug 2012 10:16:18 -0700, Jim Bennett <w6jhb at mac.com> wrote:

>Still have issues with this. Here are the settings in Config that I'm assuming are relevant:
>
>L-Mix-R = A  b
>SPKRS = 1
>SPKR + Ph = no
>SQ Main = Sub Pot
>SQ Sub = Sub Pot
>Sub AF = Nor
>
>With these Config settings, the K3 works fine with the SubRX turned off; equal Main audio in both headphones. When I turn on the SubRX, it is still OK; I get Main audio in the left ear and Sub audio in the right ear. I know I'm getting the Sub audio in the right ear, as I can turn the sub VFO and hear the frequency change in my right ear. BUT, as soon as I turn on Diversity, I get almost no signal in the right ear. It isn't silent - it's just that the signal that is pounding in on the Main is nearly inaudible on the Sub. If the signal being received on the Main is less than S7, I can't even hear it on the Sub with Diversity turned on. If it is an S9 or greater signal, then I can just barely hear it on the Sub when Diversity is turned on.
>
>Very strange. The SubRX works fine until Diversity mode is enabled.
>
>Any ideas? Does this need to be escalated to Elecraft Tech Support?
>
>
>On   Friday, Aug 3, 2012, at  Friday, 6:02 AM, Mike K2MK wrote:
>
>> Hi Jim,
>> 
>> One of the following might be helpful.
>> 
>> If you have CONFIG:SPKRS set to 1 and CONFIG:SPKR+PH set to YES it will turn
>> off the right channel of your headphones. Avoid the problem by turning
>> CONFIG:SPKR+PH to no when using diversity.
>> 
>> You also need to consider the setting of two other parameters which can be
>> confusing with respect to SUB RX use. The first is CONFIG:SUB AF. Depending
>> on whether you have chosen BALANCE or NOR it changes the way the concentric
>> audio control operates. The second is CONFIG:L-MIX-R which controls which
>> receiver's audio is in which ear. This control gets overridden when
>> diversity is used and reverts to MAIN in left ear and SUB in right ear. So
>> you might have one arrangement set for general SUB RX use and when you go to
>> diversity it changes.
>> 
>> 73,
>> Mike K2MK
>> 
>> 
>> 
>> Jim Bennett wrote
>>> 
>>> I just recently added the sub receiver to my K3. I've been using the Sub
>>> receiver (without diversity turned on) and all was fine. I have the Yamaha
>>> CM500 headset - one cable plugged into the Phones jack and the other going
>>> to the Mic jack. I also have an Icom SP-20 external speaker, and it's
>>> connected to the Spkrs jack. 
>>> 
>>> Well, I engaged Diversity mode and at first thought it was working
>>> properly. But, when I turned the AF to zero on the Main receiver, I
>>> realized that the audio on the Sub was almost nonexistent signals are
>>> there, but really, really weak. OK, so looking at the Config parameters, I
>>> noticed in the KRX3 manual that SPKRS should be set to 1. Mine was set to
>>> 2. I changed it to one and now have zero audio coming from the Sub
>>> receiver. Not exactly what I was hoping for.
>>> 
>>> What do I need to do to get my headphone audio in Diversity mode to act as
>>> it does with the Sub turned on, but Diversity off? 
>>> 
>>> Confused, I am.
>>> 
>>> Jim / W6JHB
>>> 
>> 
>> 
>> 
>> 
>> --
>> View this message in context: http://elecraft.365791.n2.nabble.com/K3-Phones-Diversity-Question-tp7560223p7560229.html
>> Sent from the Elecraft mailing list archive at Nabble.com.
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html