[Elecraft] P3 hookup

[Mike]

I wonder if that's dependent on the chip. I have one of the old style 
with the upgrade chip and it ranges from 2400 to 57600.

73, Mike NF4L

On 8/2/12 3:07 AM, Ian White GM3SEK wrote:
> Don Wilhelm wrote:
>> That will work ONLY if the SteppIR can listen in on 38400 bps traffic.
>> If it needs any other speed, then you must put the "Y" on the P3.
>>
>> Check the data speeds that the SteppIR will handle.
>>
> The older SteppIR controller can only handle up to 19200 bps. That speed
> must be manually configured in all three devices - the SteppIR
> controller, the computer and the P3 - and the SteppIR controller MUST be
> connected at the INput of the P3 (NOT to the K3)
>
> The connection between the P3 and the K3 will always be automatically
> reconfigured to 38400 bps (regardless of the manual configuration
> setting in the K3) so an older SteppIR controller cannot read the
> traffic at this speed.
>
> The newer SteppIR SDA-100 controller can handle 38400 bps so it could be
> connected to either the K3 or the P3, but again this speed must be
> manually configured in all three devices.
>
>