[Elecraft] KSB2 Problem with Assembly

[KC9QQ]

I am currently in the process of assembly a KSB2 (REV E KSB2 PC Board) which
I purchased with my K2 in November 2011.  I am currently completing the
installation of the resistors on the back side of the board.  After I
completed installing the resistors I noticed that I had an extra 10K
resistor.  I then checked my inventory and it showed that I had inventoried
3 10K resistors versus the 2 called for in inventory sheet.  

Just to be safe I downloaded the latest manual and compared it to my manual. 
It lists an additional four resistors on the back of the board (R21, R22,
R23 and R24). 

I have two questions:

1.  Should I be concerned that these resistors are not on the Rev E board?

2.  What is the purpose of the additional resistors?

Thanks,

Fred, KC9QQ



--
View this message in context: http://elecraft.365791.n2.nabble.com/KSB2-Problem-with-Assembly-tp7560131.html
Sent from the Elecraft mailing list archive at Nabble.com.