[Elecraft] what am I doing wrong?

[KC6CNN]

Ok, Let me start again, but this time from the computer. 
I have a Elecraft K3 and it is hooked up to a signalink. Going to my lap top
which is running a older version of HRD. I decode PSK31 fine business. I am
putting out about 25 watts and have yet to make a contact. I did name a
contact on CW, but everything I try in PSK doesnt work. 
I check out what Don had told me and I do not have anything showing on the
ALC in Data A mode. 
No matter if I turn up the line in gain or the tx knob on the signalink. 
My output meter shows 25 watts, but no alc. The compression is off. and I
have the center marker set for 1500 on the software. 

agc is fast. atu in active, swr on 40 meters is 1.0 - 1 and am using fl1 2.8
as the transmit filter. 

hope this helps explain some, so I can try to figure this out. 
Thanks for all the replies and help. nice to have this reflector and a great
bunch of hams on here. 

any and all ideals are greatly appreciated. 
Gerald - KC6CNN


--
View this message in context: http://elecraft.365791.n2.nabble.com/what-am-I-doing-wrong-tp7493647p7494185.html
Sent from the Elecraft mailing list archive at Nabble.com.