[Elecraft] (K3) 12VDC Current Mod Kit Received

[Ron D'Eau Claire]

See Figure 4 on page 3 of the instructions showing how to remove the fan
panel, "If Equipped with the K144XV, Unplug the ANT3 Cable Here" and an
arrow pointing to the connector on the K144XV module.

73, Ron AC7AC 

-----Original Message-----

One issue with the instructions is that they have you remove the fan panel,
or the blank panel if you don't have the KPA3. What is not taken into
consideration is if you also have the K144XV installed, with it's ANT3
connection on the fan panel. The instructions do not tell you to remove the
ANT3 cable/connector. I was able to do the mod (carefully) without
completely removing the fan panel, just loosening the screws. The
instructions also never tell you to re-install the bottom rear panel, but I
imagine most ops will remember to do that...
73,
Bruce, N1RX