[Elecraft] K1 KBAT1 bracket

[Don Wilhelm]

Byron,

I don't know just how much your bracket is extending above the side 
panel, but there is a slight bit of contact intended to keep the bracket 
from rattling around.
Your solution is probably correct, but just cut a little at a time so 
you don't go too far.

73,
Don W3FPR

On 4/21/2012 4:43 PM, Byron Servies wrote:
> Hi there!
>
> I have finally decided to give the KBAT1 I've had sitting here for a
> while a try.  I've relocated my K6XX CW tuning indicator so that the
> battery bracket will fit, but I'm having trouble with the bracket +
> new top cover combination.
>
> The bracket is fully down on the stop, but on the battery/switch side
> the top cover will not sit flush.  It seems the groove for the bracket
> is not deep enough.
>
> Before I break out the dremel or a file and solve the problem, has
> anyone else seen this issue?  And what did you do about it?
>
> 73, Byron N6NUL