[Elecraft] K2 Accessing TP3 with KDSP installed

[Don Wilhelm]

Byron,

No, you cannot get a probe to TP3 with the KDSP2 in place.
However, unless you have identified a problem that has occurred since 
the last time you checked the PLL Reference range, it is not likely to 
change.  I would say skip it - but if you find other PLL "strangeness", 
then remove the KDSP2 to check it.

73,
Don W3FPR

On 4/21/2012 4:50 PM, Byron Servies wrote:
> Hi there!
>
> Last week I finished my now fully loaded K2 #7077 and thought I would
> go through and re-do all of the various calibration steps.  It became
> immediately clear that TP3 is now covered by the KDSP.
>
> Is there a recommended way to perform these calibrations with the KDSP
> installed?
>
> 73,  Byron N6NUL
> K1 #2799
> K2 #7077