[Elecraft] K2 Audio Level using filters

[Earl Richardet]

Hello to the Reflector,

 

I've recently completed building my Elecraft K2 transceiver and I have one
problem that I would like to resolve.  Up to the point where I installed the
SSB kit into the radio, the audio level on each of the filter selections was
strong and working fine.  After I installed the SSB kit, the audio level on
the CQ filters dropped off significantly.  The OP1 SSB filters are working
great and have strong audio output, but as soon as I select FL3 or FL4 the
audio drops way off.  Otherwise the SSB board is working fine and I great
audio reports from other stations on my transmit audio.

 

At this point I have confirmed all the components on the SSB, no bridges or
splatter that I can see.  Everything appears to be ok.   Don't know where to
start troubleshooting this issue.

 

Appreciate any suggestions on troubleshooting or if anyone has experienced
this themselves and of course what you did  to resolve.

 

Thanks and Regards,

 

Earl VE7QJ