[Elecraft] Cannot get to "Config" menu after installing KPA3

[Dick Dievendorff]

The K3 Utility doesn't know the KPA3 is there unless you enable the KPA3
configuration menu selection.

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Dave (K7DRT)
Sent: Saturday, April 07, 2012 8:53 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Cannot get to "Config" menu after installing KPA3

I just finish assembling my K3/100. 

All went well until that last step of installing the KPA3. Now if I attempt
to go to the CONFIG menu the radio beeps (It cycles from normal to main).
The config menu never appears.

I updated firmware using the K3 Utility. The problem still exists.

The utility transmit calibration menu has the 50 watt test not highlighted
(not available).

I will look at responses to this before pulling the KPA3 out.

Thanks and 73,

Dave (K7DRT)

Tucson, Az.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html