[Elecraft] [K3] KPA500/K3 software suggestion

[iain macdonnell - N6ML]

There may be a case for user-defined macros that get executed when the
KPA500 changes to operate / standby mode.....

    ~iain / N6ML



On Fri, Apr 6, 2012 at 6:01 PM, Guy Olinger K2AV <olinger at bellsouth.net> wrote:
> Interesting, but wouldn't you also have to know which ANT jack on the
> back of the K3 had the KPA500?  How is it possible for the firmware to
> know? The rule would be if KPA500 enters Operate mode and the K3 is
> switched to the ANT jack that had the KPA500....
>
> 73, Guy.
>
> On Fri, Apr 6, 2012 at 8:49 PM, Carl Clawson <carlclawson at frontier.com> wrote:
>> When the KPA500 enters Operate mode, shouldn't it do the following?
>>
>> 1) Set the K3 to PWR SET = PER BAND, so that the remembered KPA500 drive
>> settings take effect.
>>
>> 2) Turn off the ATU in the K3
>>
>> 73, Carl WS7L
>> K3 #486
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html