[Elecraft] P3 Cal Question

[Fred Jensen]

On 4/1/2012 9:05 PM, Alan Bloom wrote:

> It could be that the IF output mod was never done on your K3.  I'm
> pretty sure S/N 642 was before the change was made in production.

I'm thinking that's it.

> Another possibility:  Were you using a CW or a modulated signal for
> calibration?

Just a CW signal from the service monitor.

> Another possibility:  If the K3's CONFIG:SMTR MD is set to NOR (normal)

It's set to ABS

Not going to worry about it, I was just curious.  The P3 matches the 
S-meter now, that's all I cared about.  Thanks

73,

Fred K6DGW
- Northern California Contest Club
- CU in the 2012 Cal QSO Party 6-7 Oct 2012
- www.cqp.org