[Elecraft] Questions about diversity mode

[Don Wilhelm]

Do you have a factory built K3?  If so, the subRX AUX ANT is connected 
to the BNC jack, not to the ANT port that the MAIN is using.  To do what 
I believe you want to do, you will have to installed the TMP cable that 
came with your K3 between the Sub AUX RX input and the KAT3.

73,
Don W3FPR

On 9/29/2011 12:18 PM, tomb18 wrote:
> Hi I have two antennas, one a dipole for 40m and a vertical for 20-10m.  I
> have tried to use the diversity mode with the dipole as ant1 and the
> vertical as ant2, but I get no signal on the sub receiver.  I have the
> antenna tuner and I have tried using bset changing it to ant2 but it doesn't
> seem to work.
> I do not have anything attached to the aux antenna and I think that the
> config settings are set correctly.
> Any ideas?
> Thanks
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/Questions-about-diversity-mode-tp6844510p6844510.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>