[Elecraft] P3 - Wandering Baseline

[Fred Jensen]

On 9/22/2011 6:28 PM, Don Wilhelm wrote:
> Fred.
>
> Check the coax between the K3 and the P3. I think you will find the
> problem solution there.

I've tried three different jumpers [the one that came with the P3, and 
two others I'm very sure are good], with no change.  Most of the time, 
the P3 works just great.  I'm pretty certain the case screws/2-D 
thingy's are grounded, I took the pieces off and they all show 
continuity and no paint.

Before cluttering up the list anymore, I'll try to figure out the P3 
Utility and see if I can get a screen capture.  It may take a bit of 
time since this anomaly occurs only infrequently.

73,

Fred K6DGW
- Northern California Contest Club
- CU in the 2011 Cal QSO Party 1-2 Oct 2011
- www.cqp.org