[Elecraft] vpse

[Jim Campbell]

Don,

Assuming that you have VSPE installed;
- start VSPE
- click on the icon that looks like a serial connector with a red asterisk.
   This will create a new device.
- under device type choose "Splitter" then click on "Next"
- under "virtual serial port" choose an unused serial port (example - Com 1)
- under "data source serial port" choose the physical serial port your 
devise is using
   (example - Com 4)
- under "settings" enter the serial device settings
- check mark for Redirect modem registers
- click on "Finish"
- for each of the programs that will use the serial port choose the 
virtual serial port
   (example - Com 1)

73,

Jim - W4BQP


On 9/16/2011 10:22 AM, W2XB wrote:
> A little off subject. Can anyone help me setup "VPSE" emulator. I would like
> to use my logging software etc. using the same serial port.  Keep trying to
> set it up but can't seem to get it going. Any help would be appreciated....
>
> Don.....w2xb
>
>
>