[Elecraft] KPA-500 fuse block door

[k2zf50 at aol.com]

Hi,



The Radio Shack fuses that I am using because Elecraft forgot to include them with my KPA-500 may be the reason the fuse block door is not closing. I have the fuse block seated correctly. There is a resistance to push the fuse block into the KPA-500 and I have done that correctly. I am going to call Elecraft and have them send me the fuses that were not included with my amplifier.


Thanks for everyone's suggestions.



73, Jim Douglas  K2ZF




-----Original Message-----
From: Mike Fatchett W0MU <w0mu at w0mu.com>
To: elecraft <elecraft at mailman.qth.net>
Sent: Thu, Sep 15, 2011 7:05 pm
Subject: Re: [Elecraft] KPA-500 fuse block door


You should have received a fuse package for both 220 and 110v fuses.  
The door should close.

On 9/15/2011 8:39 PM, k2zf50 at aol.com wrote:
> Hi,
>
>
> I just received my factory built KPA-500 amplifier. The fuses were not 
included with the amp so I went to Radio Shack and picked up two 3 AG 6 amp 
fuses for 240 v operation.
> With the fuses installed the fuse block door will not close. Is this normal? 
With the fuses out of the fuse block the door closes perfectly but with the 
fuses installed I just can't close it.
>
>
> Any suggestions?
>
>
> Thanks,
> Jim Douglas  K2ZF
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

-- 
J6/W0MU November 21 - December 1 2011 CQ WW DX CW

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html