[Elecraft] KPA-500 fuse block door

[Barry Simpson]

Hi Jim

My recollection is that the fuses need to be very firmly seated otherwise
there is a problem as you indicate. I had a sismilar issue until I realised.

Regards

Barry Simpson  VK2BJ

On 16 September 2011 02:39, <k2zf50 at aol.com> wrote:

> Hi,
>
>
> I just received my factory built KPA-500 amplifier. The fuses were not
> included with the amp so I went to Radio Shack and picked up two 3 AG 6 amp
> fuses for 240 v operation.
> With the fuses installed the fuse block door will not close. Is this
> normal? With the fuses out of the fuse block the door closes perfectly but
> with the fuses installed I just can't close it.
>
>
> Any suggestions?
>
>
> Thanks,
> Jim Douglas  K2ZF
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>