[Elecraft] K3s and P3s Can't Swim

[Alexey Kats]

Lee,

Out of sheer curiosity, did you mean 150 degrees Celsius or Fahrenheit? (For
the record - 150 F is approximately 65 C, quite normal for electronics. On
the other hand, 150 C is approximately 300 F - a little bit too high, I am
afraid. Not too high to cause the solder to melt, but still too high,
especially to things like TFT monitors or LCD displays.)

On Wed, Sep 14, 2011 at 6:24 PM, Lee Buller <k0wa at swbell.net> wrote:

>
> Well, get the insurance for sure.....
>
> But, I've seen electronics cleaned out with a hose with clean water.  Then
> I've
> seen them dried with a hair dryer....or baked slowly in an over at 150
> degrees.....  Then....the worked.
>
> Lee
> K0WA
>

-- 
Alexey Kats (neko)