[Elecraft] K3 band stacking suggestion

[John Oppenheimer]

and the 10 Quick Memories enable band
> to band hopping with ease.  The Quick Memories will go back to the last 
> used frequency on a band

Looking at the Config option "MEM 0-9." Adding band stacking requires
having multiple memories for each band. The additions could be:

Add a config option to enable band stacking

in "MEM 0-9" after this:
>From then on, tapping M>V , then #1 , will take you to your last-used
frequency on 160 m, just as if you had used the BAND switch.
Add this:
If "Band Stacking" is enabled, tapping M>V , then #1 again. will take
you to your last-used frequency on 160 m in the next band stack memory.

The next level of utility would be to add a configuration parameter
which remaps a user selectable button to rotate through the
bands stacking registers on the present band. Possible suggestions are:
XIT, REV(hold), MODE. This addition will add an easy single button push
to rotate through the stacking registers.

Having the above config remap button allows one to use band stacking
without enabling "MEM 0-9" The process would be to use BAND to switch to
a band, then use band stack toggle button to rotate through the stacking
memories.

John