[Elecraft] K3 and DXDoubler URGENT please!

[Jorge Diez - CX6VM]

thanks Rob, Joe, Dave, Ted for the help.

finally was a problem in the DXD K3 cable, in the mono audio connector. No
connectivity between the outside point of the connector and inside tab.

I replaced the audio mono connector of the DXD cable and now it´s running.

Thanks very much, so now 2 hours to sleep, hi hi....

73,
Jorge
CX6VM

-----Mensaje original-----
De: Joe Subich, W4TV [mailto:lists at subich.com] 
Enviado el: Viernes, 28 de Octubre de 2011 07:12 p.m.
Para: Jorge Diez - CX6VM; Elecraft Reflector
Asunto: Re: [Elecraft] K3 and DXDoubler URGENT please!


Are you sure the DXDoubler is properly passing the mic audio?  The
DX Doubler schematic shows a DC connection from the mic jack to
each of the "radio" jacks via a DPDT relay that switches both the
mic hot and mic ground.  I would suspect you have either a bad relay
or have not wired the cable between DXDoubler and your K3 correctly.

73,

    ... Joe, W4TV


On 10/28/2011 3:31 PM, Jorge Diez - CX6VM wrote:
> Hello,
>
>
>
> I can TX with my Yamaha CM500 in the back of my K3 with MENU MIC SEL =
rP.L
> bIAS
>
>
>
> now I connected DXDoubler, add the little battery bias to the CM500 as Rob
> told me, and turn OFF bIAB, so now I have MENU MIC SEL = rP.L
>
>
>
> But I cannot get ON AIR with the K3.
>
>
>
> My second radio for SO2R is a TS850 and is TX properly.
>
>
>
> I appreciate any help, this must me my sleeping hours pre contest hi hi.
>
>
>
> 73,
>
> Jorge
>
> CX6VM/CW5W
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>