[Elecraft] K3 - Allocating macros

[GW0ETF]

Should have been a bit more thorough here 'cos I've just found a post from
Rich VE3KI from earlier in the year which goes a way to explaining. Seems
you can store in both Hold and Tap but if there's only one macro in an M key
(tap or hold) then it's run by just tapping.

This is neat as I've now got my macro to switch between the sub rx audio mix
A-Ab <-> Ab-Ab on one M key; it's now a quasi toggle action to swap by
either Holding or Tapping....and leaves the others for the 3 voice messages
I'll need for this weekend's play in cqww.

Still wondering about the Bank 1/2 thing though....

73,

Stewart, GW0ETF


GW0ETF wrote:
> 
> Been using macros for a long time but only just noticed the
> following......
> 
> When allocating a stored macro to one of the M* keys it appears to give me
> the choice of Tap or Hold (eg 'M4H Set'). This would allow 8 to be stored
> in M1-M4. However when stored in either Tap or Hold the macro is run
> whether the key is tapped or held, no difference.
> 
> The stored macro also ignores Bank 1/2 selection ie written to both. Is
> this the way it's supposed to happen?
> 
> 73,
> 
> Stewart, GW0ETF
> 


--
View this message in context: http://elecraft.365791.n2.nabble.com/K3-Allocating-macros-tp6935743p6935805.html
Sent from the Elecraft mailing list archive at Nabble.com.