[Elecraft] P3: Can the Panadapter be used with a Ten Tec

[Lu Romero]

Yes, that would work, but then I would also have to take the
K3 with me as well.  Trying to travel "light".

Several have made the suggestion to place back to back
protection diodes on the P3 input, set the P3 to a
convenient below 22mhz frequency, tune the rig being tested
to that frequency and the P3, being a self contained
receiver, will show the waveform.  I think this is the
direction I will go.

-lu-w4lt-

-------------------


Message: 21
Date: Mon, 24 Oct 2011 17:52:43 -0700
From: Alan Bloom <n1al at sonic.net>
Subject: Re: [Elecraft] P3: Can the Panadapter be used with
a Ten Tec
    Orion 1?
To: lromero at ij.net
Cc: elecraft at mailman.qth.net
Message-ID: <1319503963.1589.3.camel at ulinux-desktop>
Content-Type: text/plain; charset="UTF-8"

Hi Lu,

Why not just tune the K3 to the RF output frequency of the
Orion?  The
K3's IF output signal is picked off before the crystal
filters, so the
P3 shows the actual unfiltered signal received at the K3
antenna
connector.

Alan N1AL