[Elecraft] AF peak filter

[Dick Dievendorff]

It's in the firmware release notes.

MCU 4.31 / DSP 2.72, 3-23-2011

< other text removed >

Remote-Control/Switch Macro Command Changes:

* "AP" COMMAND TURNS APF ON/OFF: You can turn the CW audio peaking filter
on/off by sending "AP1;" or "AP0;", respectively.
Applies only in CW mode with CONFIG:DUAL PB set to APF. (Not yet available
for direct sub receiver control. Swap VFOs or do A>B copy in order to set up
sub receiver APF.) You can use this command to create a TAP function to turn
APF on/off; use the Help function in K3 Utility for details on macros.

Dick, K6KR

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Georges Ringotte
F6DFZ
Sent: Wednesday, October 19, 2011 11:05 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] AF peak filter

Hi to the group,

Is it possible to write a macro command switching on or off the AF peak
filter ?
I do not see anything in the programmer reference document.

Best regards

Georges