[Elecraft] W2 problems

[Brian & Cyndi]

Hi, Steve!

Obviously the symptoms you are describing are very unusual.  The W2 
should never shut off by itself.  I suggest trying to run the W2 with a 
different power supply.  It kinda sounds like the present power 
connection is getting overloaded.

73,
Brian, W6FVI


On 10/18/2011 11:36 AM, Steve Bunting wrote:
> Hi gang,
>
> I have a w2 wattmeter that worked well when it was first built and has
> been in storage for the last few months. Now, when I apply DC the start
> up calibration routine runs just fine and the meter is ready to go.
> However, when I apply RF several LEDs light as expected but within a
> second or so the meter turns itself off. I have tested with a dummy load
> rather than an antenna and different frequencies and at RF power levels
> all with the same result. Once the meter is off I can restart it by
> simply pressing the power button again.
>
> Any idea what has gone wrong and how I can fix this issue?
> 73
> Steve
> M0BPQ
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>