[Elecraft] My KPA500 has no 270v

[tomb18]

Well I just finished my kit and I power it up and press the HV button as
instructed to, and I get .1V on the LCD. If I do press operate I get a hard
fault of 270V error.
I checked the interlock switch and it's ok.  I also powered up the unit with
the rear panel off and measured the actual 270V line (gray wire) and it
measures 11 volts.  Sigh, without a schematic, I'm not sure where to go at
this point.  I'll send an email to support but I guess I'll have to wait to
the week days.
Anyone have any ideas?

Thanks, Tom
VA2FSQ

--
View this message in context: http://elecraft.365791.n2.nabble.com/My-KPA500-has-no-270v-tp6897042p6897042.html
Sent from the Elecraft mailing list archive at Nabble.com.