[Elecraft] K-3 KPA3 Help

[iain macdonnell - N6ML]

On Fri, Nov 25, 2011 at 6:30 PM, Howard Stephenson
<hlstephenson at gmail.com> wrote:
> I'm in the final stages of my K-3 build.
> When I went to install the KPA3 I noticed a pin missing on connector
> P68A which plugs into the KPAIO3 board. It appears to be cut off
> flush.
> Is this normal?

Is the corresponding hole on J68A on the KPAIO3 board plugged? It may
be keyed so that you can't plug the KPAIO3 in backwards. According to
the schematics, pins 5 and 6 on J68A/P68A are not used.

73,

    ~iain / N6ML