[Elecraft] KPA-500 no RF until power cycle

[Geoffrey Downs]

Thanks for the suggestion Jack but TX INH is set to OFF here.

No doubt the solution will be simple but I haven't found it yet.

73 to all.

Geoff
G3UCK
K3 #266


-----Original Message----- 
From: Jack Brindle
Sent: Friday, November 25, 2011 1:59 PM

This problem is typically caused by the K3's TX INH input being enabled. Be 
sure that the Config:TX INH menu setting is set to OFF.
I emphasize, this is a K3 setting, not KPA500.

Jack Brindle, W6FB