[Elecraft] CAT command of K3 VOX??

[Jack Brindle]

The IC command will give you what you want. Voice VOX status is  
available in bit 6 of Byte d.

Jack B, W6FB


On Nov 23, 2011, at 12:17 PM, tomb18 wrote:

> I am attempting to use CAT commands to program the K3 to go into  
> something I
> call remote or local mode (using HRD with macros assigned to buttons)
>
> Basically, remote mode switches the MIC to Line in and sets the  
> compression
> to 0.  What is missing is to set PTT.
>
> Local mode, switches MIC to front panel and sets compression to 15.   
> What is
> missing is to set VOX.
>
> Now I can use the SWH09 command but this is a toggle.  It works, but  
> if I
> was to inadvertently press one Remote or Local twice in a row, then  
> the VOX
> gets switched again and this will lead to an indeterminate state  
> where I
> won't know what is happening.  As I am using the SignaLink USB  
> interface, it
> uses hardware PTT and this can occur when VOX is enabled, which may  
> cause
> some issues.
>
> Now, it seems that the VX command is only a Get.  Can anyone suggest  
> a work
> around?
>
> Thanks
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/CAT-command-of-K3-VOX-tp7025990p7025990.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html