[Elecraft] K3 RX ANT OUT

[Joe Subich, W4TV]

On the K3 manuals page ... where it's been in various incarnations
for some three years.

http://www.elecraft.com/manual/K3_Schematics_Jun_2010.pdf

73,

    ... Joe, W4TV


On 11/22/2011 9:04 PM, Bill K9YEQ wrote:
> Joe,
>
> Out of passing interest I tried to find the references you made below
> without success.  Would you be so kind as to give me a direct link to the
> schematic and the RF board.  I need to consider my internal jumper to make
> some SUB receiver changes to antenna connections.
>
> Thanks a bunch.
>
> 73,
> Bill
> K9YEQ
>
> -----Original Message-----
>   >  Is there a diagram anywhere showing the internal connections to the RX>
> ANT OUT jack?
>
> Page 38 (KXV3) and 39 (KXV3A) of the K3 schematics set on the Elecraft Web
> site.  It also helps to look at the RF Board (pg 4).
>
> 73,
>
>      ... Joe, W4TV
>
>
> On 11/22/2011 8:37 PM, Barry N1EU wrote:
>> Is there a diagram anywhere showing the internal connections to the RX
>> ANT OUT jack?
>>
>> It obviously isn't working as I expected.  I thought RX ANT OUT would
>> pass whichever of TX ANT or RX ANT that was not selected by the main
>> rx.  But with TX ANT used by main rx, RX ANT is not getting passed to
>> RX ANT OUT as I expected it to be.
>>
>> Thanks&   73,
>> Barry N1EU
>> ______________________________________________________________
>
>