[Elecraft] K3 RX ANT OUT

[Bill K9YEQ]

Joe,

Out of passing interest I tried to find the references you made below
without success.  Would you be so kind as to give me a direct link to the
schematic and the RF board.  I need to consider my internal jumper to make
some SUB receiver changes to antenna connections.

Thanks a bunch.  

73,
Bill
K9YEQ

-----Original Message-----
 > Is there a diagram anywhere showing the internal connections to the RX  >
ANT OUT jack?

Page 38 (KXV3) and 39 (KXV3A) of the K3 schematics set on the Elecraft Web
site.  It also helps to look at the RF Board (pg 4).

73,

    ... Joe, W4TV


On 11/22/2011 8:37 PM, Barry N1EU wrote:
> Is there a diagram anywhere showing the internal connections to the RX 
> ANT OUT jack?
>
> It obviously isn't working as I expected.  I thought RX ANT OUT would 
> pass whichever of TX ANT or RX ANT that was not selected by the main 
> rx.  But with TX ANT used by main rx, RX ANT is not getting passed to 
> RX ANT OUT as I expected it to be.
>
> Thanks&  73,
> Barry N1EU
> ______________________________________________________________