[Elecraft] Diversity mode preamp

[Joe Subich, W4TV]

 >> Yes, Preamp Off:      PA0;PA$0;
 >>       Preamp On:       PA1;PA$1;
 >>       Attenuator Off:  RA00;RA$00;
 >>       Attenuator On:   RA01;RA$01;
 >
 > Is there a way to do this for both receivers?

Yes, this does it for both receivers ... for example PA0; does the
main receiver and PA$0l does the KRX3.

 > Yes. Please observe that I was not the one asking for changes, but
 > rather asking it the commands are already there.  :)

I know that but it takes less time to read the programmers guide and
write the macros in AutoHotkey (add CATASC for N1MM to send the
information in the CAT stream) than has been wasted on this topic in
the last two days.

It would very little time to design a keyboard with microprocessor
and two serial ports ... DATA IN and DATA OUT ... to set between the
computer and K3 to add any given number of special commands (like
the four already shown).  The hardware is probably available off the
shelf from X-Keys.

73,

    ... Joe, W4TV


On 11/22/2011 3:23 PM, Jim Brown wrote:
> On 11/22/2011 12:01 PM, Joe Subich, W4TV wrote:
>> Yes, Preamp Off:      PA0;PA$0;
>>       Preamp On:       PA1;PA$1;
>>       Attenuator Off:  RA00;RA$00;
>>       Attenuator On:   RA01;RA$01;
>
> Is there a way to do this for both receivers?
>>
>> It's quite simple if one reads the K3 Programmer's Reference instead of
>> blindly demand changes to the K3 firmware.
>
> Yes. Please observe that I was not the one asking for changes, but
> rather asking it the commands are already there.  :)
>
> It should also be noted that K6XX, a top contester with a great multi-op
> station and an excellent engineer, has been part of the engineering team
> at Elecraft for some time now.
>
>   >Tom doesn't really need anything. Guest operators are the real worry.
>
> Understood, and I'm sure that XX understands that too.
>
> 73, Jim K9YC
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>