[Elecraft] SignaLink Wiring

[Joel Black]

Well, I appreciate the help, but I cannot get the SignaLink working.  I 
can use my computer soundcard, but not the SLUSB.  I was even able to 
make a WINMOR connection (with the PC soundcard); however, my transmit 
to receive turnaround time is slow.  I read about making the radio use 
the same tx and rx filters.  I'll try that.

Regarding the SLUSB, I may not be hooking it up correctly on the back of 
the radio, but I'm not sure where else I'd hook it up without turning 
off something on the front.  I'm using LINE IN and LINE OUT for audio, 
but nothing seems to make it to the software (any software).

I'm new to this K3 and I know I'll eventually figure it out.  I will 
admit, I have not completely read the manual - I have been focusing on 
the DATA section.

Thanks again.

73,
Joel - W4JBB

On 11/18/2011 5:44 PM, Joel Black wrote:
> If anyone is using the SignaLink USB, can someone tell me the wiring to
> the K3?
>
> I think I have rolled Line In and Line Out.
>
> Here's what I have:
>
>   From the SignaLink RJ-45:
>
> Pin 1 ->  SPKR goes to LINE IN (mono) on the K3
> Pin 2 ->  GND
> Pin 3 ->  MIC goes to LINE OUT (stereo connection with tip and gnd only)
> on the K3
> Pin 4 ->  GND
> Pin 5 ->  PTT goes to PTT IN on the K3
> Pin 6 ->  GND
>
> Please don't get into the argument about how I can just use the LINE
> IN/LINE OUT and connect to my computer's soundcard.  I am aware of
> that.  I have very specific and very good reasons for using the
> SignaLink.  I just need some help with the wiring.
>
> Thanks,
> Joel - W4JBB